Renewable Energy

Renewable energy is energy from a source which can be managed so that it is not subject to depletion in a human timescale . Sources include the sun's rays, wind, waves, rivers, tides, biomass, and geothermal. Renewable energy does not include energy sources which are dependent upon limited resources, such as fossil fuels and nuclear fission power.

General information

Most renewable forms of energy, other than geothermal and tidal, are in fact stored solar energy. Water power and wind power represent very short-term solar storage, while biomass represents slightly longer-term storage, but still on a very human time-scale, and so renewable within that human time-scale. Fossil fuels, on the other hand, while still stored solar energy, have taken millions of years to form, and so do not meet the definition of renewable. Renewable means not just for 10 years but for 100 or 1000.

Renewable energy resources may be used directly as energy sources, or used to create other forms of energy for use. Examples of direct use are solar ovens, geothermal heat pumps, and mechanical windmills. Examples of indirect use in creating other energy sources are electricity generation through wind generators or photovoltaic cells, or production of fuels such as ethanol from biomass (see alcohol as a fuel).

Around 80% of energy requirements in western industrial societies are focused around heating or cooling buildings and powering the vehicles that ensure mobility (cars, trains, airplanes). However, most uses of renewable power focus on electricity generation.

Modern sources of renewable energy

There are several types of renewable energy, including the following:

•    Solar Power
•     Wind Power
•     Geothermal energy
•     Electrokinetic energy
•     Hydroelectricity.
•     Energy from biomass, also called biomatter energy

Renewables as solar energy

Most renewable energy sources can trace their roots to solar energy, with the exception of geothermal and tidal power -- yet even these can be attributed to the sun's gravity. For example, wind is caused by the sun heating the earth unevenly. Hot air is less dense, so it rises, causing cooler air to move in to replace it. Hydroelectric power can be ultimately traced to the sun too. When the sun evaporates water in the ocean, the vapor forms clouds which later fall on mountains as rain which is routed through turbines to generate electricity. The transformation goes from solar energy to potential energy to kinetic energy to electric energy.

Solar energy per se

Since most renewable energy is "Solar Energy" this term is slightly confusing and used in two different ways: firstly as a synonym for "renewable energies" as a whole (like in the political slogan "Solar not nuclear") and secondly for the energy that is directly collected from solar radiation. In this section it is used in the latter category.

There are actually two separate approaches to solar energy, termed active solar and passive solar.

Solar electrical energy

For electricity generation, ground-based solar power has serious limitations because of its diffuse and intermittent nature. First, ground-based solar input is interrupted by night and by cloud cover, which means that solar electric generation inevitably has a low capacity factor, typically less than 20%. Also, there is a low intensity of incoming radiation, and converting this to high grade electricity is still relatively inefficient (14% - 18%), though increased efficiency or lower production costs have been the subject of much research over several decades.

Two methods of converting the Sun's radiant energy to electricity are the focus of attention. The better-known method uses sunlight acting on photovoltaic (PV) cells to produce electricity. This has many applications in satellites, small devices and lights, grid-free applications, earthbound signaling and communication equipment, such as remote area telecommunications equipment. Sales of solar PV modules are increasing strongly as their efficiency increases and price diminishes. But the high cost per unit of electricity still rules out most uses.

Several experimental PV power plants mostly of 300 - 500 kW capacity are connected to electricity grids in Europe and the USA. Japan has 150 MWe installed. A large solar PV plant was planned for Crete. In 2001 the world total for PV electricity was less than 1000 MWe with Japan as the world's leading producer. Research continues into ways to make the actual solar collecting cells less expensive and more efficient. Other major research is investigating economic ways to store the energy which is collected from the Sun's rays during the day.

Alternatively, many individuals have installed small-scale PV arrays for domestic consumption. Some, particularly in isolated areas, are totally disconnected from the main power grid, and rely on a surplus of generation capacity combined with batteries and/or a fossil fuel generator to cover periods when the cells are not operating. Others in more settled areas remain connected to the grid, using the grid to obtain electricity when solar cells are not providing power, and selling their surplus back to the grid. This works reasonably well in many climates, as the peak time for energy consumption is on hot, sunny days where air conditioners are running and solar cells produce their maximum power output. Many U.S. states have passed "net metering" laws, requiring electrical utilities to buy the locally-generated electricity for price comparable to that sold to the household. Photovoltaic generation is still considerably more expensive for the consumer than grid electricity unless the usage site is sufficiently isolated, in which case photovoltaics become the less expensive.

Solar thermal electric energy

The second method for utilizing solar energy is solar thermal. A solar thermal power plant has a system of mirrors to concentrate the sunlight on to an absorber, the resulting heat then being used to drive turbines. The concentrator is usually a long mirrored parabolic trough oriented north-south, which tilts, tracking the Sun's path through the day. A black absorber tube is located at the focal point and converts the solar radiation to heat (about 400°C) which is transferred into a fluid such as synthetic oil. The oil can be used to heat buildings or water, or it can be used to drive a conventional turbine and generator. Several such installations in modules of 80 MW are now operating. Each module requires about 50 hectares of land and needs very precise engineering and control. These plants are supplemented by a gas-fired boiler which ensures full-time energy output. The gas generates about a quarter of the overall power output and keeps the system warm overnight. Over 800 MWe capacity worldwide has supplied about 80% of the total solar electricity to the mid-1990s.

One proposal for a solar electrical plant is the solar tower, in which a large area of land would be covered by a greenhouse made of something as simple as transparent foil, with a tall lightweight tower in the centre, which could also be composed largely of foil. The heated air would rush to and up the centre tower, spinning a turbine. A system of water pipes placed throughout the greenhouse would allow the capture of excess thermal energy, to be released throughout the night and thus providing 24-hour power production. A 200 MWe tower is proposed near Mildura, Australia.

Solar thermal energy

Solar energy need not be converted to electricity for use. Many of the world's energy needs are simply for heat; space heating, water heating, process water heating, oven heating, and so forth. The main role of solar energy in the future may be that of direct heating. Much of society's energy need is for heat below 60°C (140°F) - e.g. in hot water systems. A lot more, particularly in industry, is for heat in the range 60 - 110°C. Together these may account for a significant proportion of primary energy use in industrialized nations. The first need can readily be supplied by solar power much of the time in some places, and the second application commercially is probably not far off. Such uses will diminish to some extent both the demand for electricity and the consumption of fossil fuels, particularly if coupled with energy conservation measures such as insulation.

Wind energy

Wind turbines have been used for household electricity generation in conjunction with battery storage over many decades in remote areas. Generator units of more than 1 MWe are now functioning in several countries. The power output is a function of the cube of the wind speed, so such turbines require a wind in the range 3 to 25 m/s (11 - 90 km/h), and in practice relatively few land areas have significant prevailing winds. Like solar, wind power requires alternative power sources to cope with calmer periods.

There are now many thousands of wind turbines operating in various parts of the world, with utility companies having a total capacity of over 39,000 MWe of which Europe accounts for 75% (ultimo 2003). Additional windpower is generated by private windmills both on-grid and off-grid. Germany is the leading producer of wind generated electricity with over 14,600 MWe in 2003. In 2003 the U.S.A. produced over 6,300 Mwe of wind energy, second only to Germany.

New wind farms and offshore wind parks are being planned and built all over the world. This has been the most rapidly-growing means of electricity generation at the turn of the 21st century and provides a complement to large-scale base-load power stations. Denmark generates over 10% of its electricity with wind turbines, whereas wind turbines account for 0.4% of the total electricity production on a global scale (ultimo 2002). The most economical and practical size of commercial wind turbines seems to be around 600 kWe to 1 MWe, grouped into large wind farms. Most turbines operate at about 25% load factor over the course of a year, but some reach 35%.

Geothermal energy

Geothermal electricity is created by hot gases vented from the fissures in the earth's crust. A wheel is turned by the pressure of the gases. The wheel turns the dynamo on the generator, which makes electricity.

Where hot underground steam or water can be tapped and brought to the surface it may be used to generate electricity. Such geothermal power sources have potential in certain parts of the world such as New Zealand, United States, Philippines and Italy. The two most prominent areas for this in the United States are in the Yellowstone basin and in northern California. Iceland produced 170 MWe geothermal power and heated 86% of all houses in the year 2000. Some 8000 MWe of capacity is operating over all.

There are also prospects in certain other areas for pumping water underground to very hot regions of the Earth's crust and using the steam thus produced for electricity generation. An Australian startup company, Geodynamics, is currently using this technology in a commercial plant in the Cooper Basin region of South Australia (2004).

Hydroelectric energy

Hydroelectric energy produces essentially no carbon dioxide, in contrast to burning fossil fuels or gas, and so is not a significant contributor to global warming. Hydroelectric power from potential energy of rivers, now supplies about 715,000 MWe or 19% of world electricity. Apart from a few countries with an abundance of it, hydro capacity is normally applied to peak-load demand, because it is so readily stopped and started. It is not a major option for the future in the developed countries because most major sites in these countries having potential for harnessing gravity in this way are either being exploited already or are unavailable for other reasons such as environmental considerations.

The chief advantage of hydrosystems is their capacity to handle seasonal (as well as daily) high peak loads. In practice the utilization of stored water is sometimes complicated by demands for irrigation which may occur out of phase with peak electrical demands.

Biomass

Biomass, also known as biomatter, can be used directly as fuel or to produce liquid biofuel. Agriculturally produced biomass fuels, such as biodiesel, ethanol and bagasse (often a byproduct of sugar cane cultivation) can be burned in internal combustion engines or boilers.

Liquid biofuel (biodiesel or bioalcohol)

Liquid biofuel is usually bioalcohols -like methanol and ethanol- or biodiesel. Biodiesel can be used in modern diesel vehicles with little or no modification and can be obtained from waste and crude vegetable and animal oil and fats (lipids). In some areas corn, sugarbeets, cane and grasses are grown specifically to produce ethanol (also known as alcohol) a liquid which can be used in internal combustion engines and fuel cells.

Solid biomass

Direct use is usually in the form of combustible solids, either firewood or combustible field crops. Field crops may be grown specifically for combustion or may be used for other purposes, and the processed plant waste then used for combustion. Most sorts of biomatter, including dried manure, can actually be burnt to heat water and to drive turbines. Plants partly use photosynthesis to store solar energy, water and CO2. Sugar cane residue, wheat chaff, corn cobs and other plant matter can be, and is, burnt quite successfully. The process releases no net CO2.

Biogas

Animal feces (manure) release methane under the influence of anaerobic bacteria which can also be used to generate electricity. See biogas.

[ The above knowledge is extracted from Wikipedia, the free encyclopedia ]